Designed to provide a way to visually determine that a tank has reached maximum allowable fill capacity. The dip tube end of a fixed liquid level gauge should be set equal to 80% of the liquid level tank capacity and installed in the vapor space of the tank. The vent valve should be opened before filling begins during which time vapor will be discharged. Once the tank reaches maximum liquid fill capacity (80% of tank capacity), liquid will begin to discharge from the vent valve telling the operator the tank has reached maximum allowable fill capacity and the filling operation should cease immediately.

Designed for use on for lift cylinders and other DOT removable cylinders up to 122 pounds of LP-Gas capacity. The working components of this valve are located inside the tank reducing possible malfunction caused by outside debris and other foreign materials.

• Stainless steel spring
• Non-adjustable, tamper resistance design
• 45 and 90 degree discharge vents available

The service valves are intended for use in vapor or liquid service on DOT forklift containers.

• One piece forged brass body construction
• Industry best fill flow rate
• Dual O-ring packing design
• Factory applied thread sealant
• Easy to repair/replace bonnet assembly
• Heavy-duty replaceable zinc hand wheel
• Universal bonnet assembly

3/4" MNPT 3/8" MNPT Forklift service valve

Designed for DOT forklift, engine fuel and ASME residential tanks, these double check filler valves automatically open with pump pressure providing maximum product flow rates. Once flow ceases, both upper and lower check mechanisms close to prevent product loss from the container. The lower check serves as a secondary seat to limit product loss in the evenet that the primary upper seats fails to operate properly due to damage.

• Resilient bonded main valve seal
• Industry best flow rate
• Integral break away feature leaves primary check intact in the event of delivery truck rollaway
• Field repairable upper check seat
• Factory applied thread sealant

Universal Float Gauges (Horizontal & Vertical Mount).

The service valves are intended for use in vapor or liquid service on engine fuel containers.

• One piece forged brass body construction
• Industry best fill flow rate
• Dual O-ring packing design
• Factory applied thread sealant
• Easy to repair/replace bonnet assembly
• Heavy-duty replaceable zinc hand wheel

Specifically designed for remote filling applications where a standard tank type filler valve is not practical. Perfectly suited for motor fuel applications or other hard to reach remote tank applications. This single check fill valve is designed to provide maximum product fill rates along with an automatic shutoff once product flow ceases.

• Single check design allows maximum flow rate
• Single piece main valve body
• Integral break away feature leaves primary check intact in the event of delivery truck rollaway
• Rear bulkhead mounting with quarter panel jam nut and lock washer

1-3/4"M ACME x 1/2" m flare remote fill valve ME601-902 with cap and lanyard.